(Italian version not yet
available) HTMS is experienced in the
design and manufacture of resilient metal seals
for extreme environmental service conditions.
HTMS metal seals, O-Rings, C-Rings, spring
energised C Rings and O-Rings are produced from
high quality alloy materials with full lot
control, full traceability and inspection
procedures at all production steps.
All production procedures
starting from purchase to shipment are
controlled by our Q.A. manual. HTMS is an ISO
9001 certifi ed manufacturer of resilient metal
seals. Regular internal audits verify that work
procedures are maintained and compliant with our
Q.A. manual.
HTMS works closely with their
customers to analyse as correct as possible the
sealing problem and based on this application
data, design and manufacture the best seal for
the given application.
We strive to manufacture only
correct products and are confi dent that our
seals will be free of all material or
manufacturing defects. Should a mistake being
made then we will replace, free of charge, any
defective products with the highest priority.
Our warranty is limited to
the replacement value of the defective seals
only, and does not include any additional or
consequential liabilities.
Resilient metal seals are by
design and depending on the performance
requirement sensible seals, where other
parameters such as, handling, effective groove
sizes and surface roughness are evenly important
to achieve the desired results.
The seal, being only one part
of the sealing solution, HTMS cannot guarantee
any leakrate, nor can we accept any liability
for costs following poor sealing results.
However, should the problem be related to faulty
parts HTMS will replace free of charge the
parts.
Except for the general
recommendations found in this design manual, we
cannot give specific warranties for life-expectancy,
leak-rate or other operational parameter.
Customers are always advised
to qualify seals, preferably by real life test,
or by similarity, in the exact configuration of
their intended use.
